Plexiglas print Part II

     

        So, I have put the design of my print into the laser engraver and I believe something in the file has gone wrong because the print has been turning out like this.

      I didn't purposely put those vertical lines there. But that's okay because I go with the flow of the universe and if that's how it goes I'll go with it.  I knew that mine print wasn't going to be as clear as it could be. Because it was a drawing and not an HD picture. The wolf did not turn out how I wanted it to but the clouds did. I am quite proud of my clouds.     

       

        I think I could have done better, and I should have done a print of a picture. I've been scrolling through my camera and have found multiple photos I wish I had done a print of. Well, there are a lot of Whouda, Shoulda, Coulda's in the world.

Plexiglas Print

     
    This is my design for my Plexiglas print. I'm currently putting it through Photoshop and I'm almost done with that process. From what I have been shown,  I know that the ink will get into the grooves of the Plexiglas and I will wipe away at the surface so that its just the ink in the grooves that will stay. I'll put it through the press and the wet paper should go into the Plexiglas and soak up the ink to make the form I put on it. If this turns out well, I am going to put it in the MSHSL art competition. If it doesn't, I'll put in my deer print. I'll be finishing up working on setting the print up in Photoshop and see where it goes from there. Fingers crossed!